Getting started¶
This page takes you from a board on your desk to boot messages on your screen. It assumes you've used a terminal before, but not that you've brought up a Linux board from scratch.
What you need¶
| Item | Notes |
|---|---|
| Glasnost M9G10 board | |
| microSD card, 2 GB or smaller | The processor can only boot from standard-capacity (SDSC) cards — see Boot & recovery. |
| 5 V USB-C power supply | 1 A or more is recommended: WiFi transmit bursts draw much more than idle. |
| USB-to-serial adapter, 3.3 V | For the debug console. A 5 V adapter can damage the board. |
| Jumper wires | Three female–female wires for the adapter. |
| A computer with a terminal program | e.g. picocom, minicom, PuTTY. |
1. Prepare the microSD card¶
Ready-made images
Prebuilt images are not published yet. Until then, build the bootloaders and Linux yourself — see Software.
- Format the card as FAT (FAT16 or FAT32).
- Copy the first-stage bootloader to the root of the card as
boot.bin. The processor looks for exactly this file name. - Copy the rest of the image (U-Boot, kernel, device tree, root filesystem) as described in Software.
2. Connect the debug console¶
The debug console is a serial port that shows every boot message and later gives you a login prompt. It's on the main header (J4):
| Adapter | Board (J4) |
|---|---|
| GND | pin 14 (GND) |
| RX | pin 11 (debug console TX) |
| TX | pin 12 (debug console RX) |
Don't connect the adapter's power pin. Open your terminal program at 115200 baud, 8N1, no flow control. For example:
picocom -b 115200 /dev/ttyUSB0
3. Power up¶
- Insert the microSD card.
- Plug in the USB-C power supply.
You should see, in order: the bootloader (AT91Bootstrap) messages, then U-Boot, then the Linux kernel starting.
Note
The exact expected output for revision 2.0 hasn't been documented yet.
If nothing appears¶
- Check the adapter wiring: TX and RX are crossed (adapter TX → board RX).
- Check the card is 2 GB or smaller, FAT-formatted, with
boot.binin the root. - With no bootable card, the processor starts its recovery mode (SAM-BA) and waits for a computer on the USB-C port or the debug console — see Boot & recovery.
- Check known issues.
Next steps¶
- Connectors & pinout — what's on the header.
- Software — build your own image.