Hardware overview
What's on the board, in one place. Details for each part are on the pages linked below.
Specifications
|
|
| Processor |
Microchip AT91SAM9G10 — ARM926EJ-S core at 266 MHz, 217-ball BGA |
| Memory |
64 MB SDRAM (2× MT48LC16M16A2, 256 Mbit each, 32-bit bus) by default; up to 128 MB with 2× 512 Mbit chips (MT48LC32M16) |
| Storage |
microSD card slot (boot and root filesystem); 2 MB SPI DataFlash (AT45DB161D, data only — the boot ROM can't boot from it) |
| USB |
USB-C port: power in, USB 2.0 full-speed device, recovery. One USB host port on header J3 for a cape. A second USB host port is used by the on-board WiFi. |
| Wireless |
WiFi module (RTL8188CUS) with U.FL antenna connector; a WiFi/Bluetooth combo module with the same pinout also fits |
| Expansion |
Main header J4, 2×18 pins, 2.54 mm: debug console, 2 UARTs, I²C, SPI, 4 GPIO, reset, 3.3 V |
| User interface |
RGB status LED, one user button, one wake-up button |
| Clocks |
18.432 MHz main crystal, 32.768 kHz crystal for the real-time clock |
| Power |
5 V through the USB-C port; on-board 3.3 V and 1.2 V regulators — see Power |
| PCB |
4 layers, 66 × 42 mm — see PCB |
What's on the board
| Ref |
Part |
Function |
| U1 |
AT91SAM9G10 |
Processor |
| U2, U3 |
MT48LC16M16A2 |
SDRAM |
| U5 |
AT45DB161D |
SPI DataFlash (data storage) |
| U6 |
RTL8188CUS module |
WiFi |
| U7, U8 |
TPS62A01A |
3.3 V and 1.2 V regulators |
| J1 |
microSD slot |
Boot media |
| J3 |
2×4 header, 1.27 mm |
USB host port for a cape |
| J4 |
2×18 header, 2.54 mm |
Main header (mounted on the bottom side) |
| J5 |
USB-C |
Power and USB device |
| AE1 |
U.FL |
WiFi antenna |
| D3 |
RGB LED |
Status |
| SW1, SW2 |
Buttons |
User button, wake-up button |
| TP4–TP6 |
Test points |
5 V input, 1.2 V core, 3.3 V |
More